DeltaSafe
Ideal for use on oil platforms and wind turbines when transporting GE Energy Delta modules.
Deltasafe is an approved transportation method for the offshore & onshore transportation of delta modules in extreme environments .
Our product has come through rigorous testing including vibration, impact and crush set by our clients. The product is soft enough to hit a tower without damaging it and tough enough not to damage the product inside.
More than four years’ of research and development went into the design and build of the Deltasafe critical component protector with our clients to make sure the best solution was found for the problem.
Key facts
- Handles for ease of lifting
- Unique crane hooking point for use in tower installation, which removes load testing conditions
- Water resistant
- 8 man hours saved when using system to change power inverters in a Siemens 3.6MW tower
SitSafe
The Sitsafe critical component protector bag is tailored to meet the challenges posed by wind turbines when transporting SICS inverter modules.
Sitsafe has demonstrated its capability through a series of tests for vibration, impact and crush. 100% warranty claim reduction when used for goods damaged in transportation.
Due to the success of the DeltaSafe bag, the SitSafe bag was designed for other inverters used in the offshore wind sector, suitable for use on 6,7 and 8 MW towers.
Lightsafe
The LightSafe critical component protector has been designed to help engineers changing emergency lighting in towers.
Our product has been load tested to 15kgs with strip lighting housing pockets
The product has been designed to hold 4 strip light casings and 9 spare bulbs during repair and maintenance on wind turbines.
It has 4 compartments to hold the strip light casings, and in the centre of the compartments it has a storage area for the replacement bulbs.
This equipment is to be used when replacing/installing the strip light casing or bulbs on wind turbines.
It has been designed and developed to lift only the approved strip lighting casing and the bulbs to suit. This product has not been designed to lift sharp objects (other than broken light tubes in the centre storage area for the light tubes).
CylinderSafe
CylinderSafe has been developed specifically for use when transporting cylinders to the top of the towers.
Three standard sizes are available- standard bag – measuring 1300mm x 350mm in size including a 5mm plastic protection tray at the bottom. ( other sizes available please ask for further information )
The product has been specifically designed to enable technicians to safely and securely carry gas cylinders up towers, without the fear of the cap being damaged during lifting.
Due to the versatilabilty of the product, this can be modified to lift other products i.e. pitch ram for use in towers.
